Transfer window usage management system
The transfer window is managed according to the cleanliness level of the other clean areas connected to it. For example, the transfer window connected between the spray booth and the filling room should be managed according to the requirements of the filling room. After the shift, the operator of the clean area is responsible for wiping the internal surfaces of the transfer window and turning on the UV sterilization lamp for 30 minutes.
Passing window usage:
(1) Material entering and leaving the clean area must be strictly separated from the flow channel and accessed by the material channel of the production workshop.
(2) When the material enters, the original auxiliary material shall be unpacked or cleaned by the person in charge of the preparation process, and then sent to the temporary storage room of the original auxiliary material through the transfer window ; after the inner packaging material is removed from the outer packaging, It is sent to the inner bag through the transfer window . The workshop integrator handles the material handover with the person in charge of the preparation and internal packaging process.
(3) When passing through the transfer window , the regulations of “opening and closing†of the inner and outer doors of the transfer window must be strictly enforced, and the two doors cannot be opened at the same time. After opening the outer door, put the material into the door, then close the door, then open the inner door to take out the material, close the door, and so on.
(4) When the materials in the clean area are delivered, the materials should be transported to the relevant material intermediate station and removed from the clean area according to the reverse procedure when the materials enter.
(5) All semi-finished products are shipped out of the clean area, and all need to be sent from the transfer window to the external storage room, and the outer packaging room is transported through the logistics channel.
(6) Materials and wastes that are highly susceptible to pollution should be transported from their dedicated transfer windows to non-clean areas.
(7) After the material enters and exits, the site and the window of the transfer station should be cleaned in time, and the inner and outer access doors of the transfer window should be closed to clean and disinfect.
Transfer window usage notes:
1. Since the transfer window is interlocked, when the door on one side cannot be opened smoothly, it is caused by the fact that the door on the other side is not closed. Do not forcefully open it, otherwise the interlock device will be damaged.
2. When the material is from low level to high clean level, the surface of the material should be cleaned.
3. When the interlocking device of the transfer window cannot work normally, it should be repaired in time, otherwise it cannot be used.
4. Always check the operation of the UV lamp and replace the UV lamp regularly.
5. Do not store any materials or debris in the transfer window .
Shanghai Sujing Industrial Co., Ltd.
　　
If you have any needs, you can always pass with me, thank you very much for your support to Sujing, look forward to working with you.
　　
have a pleasant workday!
　　
Thankyou&Bestregard!
　　
SUJING—JINGHUA
Product categories Ultrasonic Plastic Welder ,We provide free sample service, 24-hour online professional ultrasonic solutions, contact us immediately. Look forward to your cooperation!
Ultrasonic Plastic Welder,Ultrasonic Plastic Welding Machine,20K Ultrasonic Welder,Ultrasonic Welder
Wuxi DIZO Ultrasonic Technology Company , https://www.dizosonic.com