How to use the drug polishing machine?

The drug polisher removes the capsules and dust on the surface of the tablets. The stainless steel cavity is used instead of the plexiglass, which is not easy to be deformed, and the stainless steel mesh cover is used, which solves the problem that the traditional mesh cloth is easy to break and needs to be replaced frequently.

The working principle of the drug polishing machine is to rotate the brush to make a circular spiral motion along the wall of the polishing tube, so that the capsule advances along the spiral spring, and the outer surface of the capsule shell is continuously rubbed against the wall of the brush and the polishing cylinder. Polished, polished capsules enter the waste bin from the discharge port. In the waste device, due to the negative pressure, the capsule under the action of the air flow, the light weight of the unqualified capsule rises, enters the vacuum cleaner through the straw, the weight of the qualified capsule continues to fall, through the active discharge hopper discharge, effectively achieve polishing Go to waste. The powder and fine fragments that are brushed off during the polishing process enter the sealing cylinder through the small holes in the polishing cylinder wall, and are sucked into the vacuum cleaner for recovery.

The operation method of the drug polishing machine is as follows:

1. Under the polishing seal cylinder, connect one of the suction pipes of the special industrial vacuum cleaner; above the waste disposal device, connect another suction pipe of the special industrial vacuum cleaner.

2. Turn on the power of the industrial vacuum cleaner and polishing machine, and adjust the rotation speed of the polishing machine. Use a small amount of waste shell capsules to test the machine, adjust the negative pressure of the waste device, so that it can just remove the empty shell fragments. If the negative pressure is too large, it is possible to remove the good capsules. If it is too small, it will not be used. The amount of waste air is adjusted in the adjustment plate of the industrial vacuum cleaner inlet, and the waste can be observed from the front observation board of the waste device. The suction air volume of the powder is also adjusted in the industrial vacuum cleaner adjustment plate.

3. After doing the above preparations, you can work.

4. Clean the polishing machine and industrial vacuum cleaner in time after each shift. Industrial vacuum cleaners should also be cleaned up during the work if necessary.