Structural features of the brush barrel capper

BS-2 series brush barrels are mainly used to adapt to the needs of the vast mineral water plants and pure water manufacturers, and turn the cumbersome empty barrel processing into automation. The factory introduced and absorbed the advanced technology of foreign brush barrels, combined with the actual situation of existing manufacturers and the requirements of drinking water industry management, developed the BS-I type brush barrel capping machine. The device is reliable, easy to operate and easy to maintain.

Brush barrel puller structure features

1. The inner brush barrel machine is composed of stainless steel square tube welding wire, transmission mechanism, pneumatic reversing and pulling, electrical control and water tank spraying. The welded parts are characterized by Mandarin resistance and corrosion resistance.

2, collecting wind, outside, spray in one, three working conditions are completed in the same work cycle, saving time, effort and power.

3. Water supply mode, using three kinds of coexisting water supply, namely circulating water supply, non-circulating water supply and double water supply, can be reasonably selected according to user needs.

4, the brushing effect is good, the machine adapts to the barrel inside and outside to avoid all-round effective brushing.

5, the operation is simple, only one operation of opening and closing the door, that is, completing the entire brushing process.

6. The inner brush barrel machine is powered by three-phase four-wire system, N is zero line. After the power is turned on, the water tank is filled with water, and the motor direction is confirmed. Close the DZ47 room, open the panel power switch, and then open the flip cover to run.

7. The inner brush barrel machine is used for the washing of 3 gallon and 5 gallon drinking water recycling barrels. It can be reused many times after disinfection to improve the utilization of the lid. This machine is pneumatically powered and safe and reliable. The gas source pressure was 0.5 MP/cm2, and the gas source capacity was 0.1 m2/min. 4. Maintenance and maintenance of the brush barrel capping machine 1. After the new machine is used, adjust the tension of the main longitudinal belt and the distance of the door limit one month later.